Film Wrapper Technical Bulletin1New York • Pennsylvania • Georgia • Texas • California China • India800-444-3595 www.winholt.comModels:WHSS-1; WHSS-2
Replacement Parts9FUSE (FUS-1) AND FUSE HOLDER (FHD)- Holds 1 AMP FUSE. Compatible with other brands.PART#WHSS-FHDWHSS-FHS 1ORDER#1131441131S2DIMENSIO
Replacement Parts10WHSS-HP8WHSS-CAPWHSS-TMWHSS-AHEATING ELEMENT- For Hot Plate. Heats to 450°F. Fits other brands.PART#WHSS-EORDER#113128DIMENSIONS9/3
Trouble Shooting11Apparent Problem CheckPoint SolutionCut-off rod fails to heat properly Test the cut off rod. Use procedure described on page 6. Chec
Assembly Instructions for WHSC-3/KD12ITEM QTY PART NUMBER1 1 Side frame2 1 Sideframe13 4 RollerAssy4 12 1/4-20 Wing Nut- UNC5 2 Spreader-Outer 20 in6
Assembly Instructions for WHSC-3/KD13Tools Required:#2 & 3 Philips Screw drivers10mm & Bmm wrench- (Socket; open end or Box)Assembly Procedure
DirectoryCustomer Service Bulletin...2Film Loading Instructions:Film Axle...
Customer Service Bulletin2CUSTOMER SERVICE BULLETINThe Win-Holt Film Wrappers are used to apply a thin plastic lm or protective plastic covering over
Loading The Film Axle3LOADING THE FILM AXLE:1. Loosen all Wing Nuts. Swing out right and left Bearing Blocks.2. Lift out the Axle Assembly. Unscrew Wi
Film Roll Axle Assembly4MODEL: WHSS-1FILM ROLL AXLE ASSEMBLY INSTRUCTIONS:1. Install Bearing Block Assembly (A) on the left side of Base, line up
Electrical Diagram5HOT PLATE WITH ELEMENTELECTRICAL DIAGRAMNew York • Pennsylvania • Georgia • Texas • California China • India800-444-3595 www.winho
Testing6TESTING THE CUT-OFF ROD:1. Disconnect the “red” CUT-OFF ROD wires from terminals 4 and 5. 2. Using an ohmmeter, measure the resistance across
Replacement Parts7CORE ADAPTER WING UNIT- Compatible with other 22 1/2”wide units. Core Adapter Pin and Wing Unit sold separately.PART#WHSS-CAWORDER#1
Replacement Parts8ELECTRIC WIRE- High Temperature wire. Used to connect Hot Plat tothe Electrical Box.PART#WHSS-EWCORDER#113136DIMENSIONSPer FootSHIPW
Comments to this Manuals